Moteur enroulable, kits d'installation partielle pour ventilation Roll Up Motor

Hardware to install the roll up motors for a venting application.

Electrical conduit supplied by the customer.

Matériel pour l'installation des moteurs d'enroulement pour une application de ventilation. Conduit électrique fourni par le client.

For houses made with 1-3/8" tube:

Ideally, the threaded-connector is installed 1 foot above the top of the roll up wall - this will allow the fullest opening. The loose-end must be very close to grade - so the wall can fully close.

The threaded-connector sits between the arch and the springwall base - to do: un-attach the poly; partially raise a screw and wiggle the bracket in place.

The1/2" EMT can either be drilled, as the tube below - or you can tap a brace pin in. To install a brace pin slightly ovalize the end of the tube with vice grips or a vice; brace the tube against something solid and tap the pin squarely (so as not to bend the pin over) till it is snug.